成人影院在线免费观看视频,欧美大鸡吧操逼视频,国产精品无码一区二区在线看

Previously, we introduced two methods for configuring interface breakout and aggregate on CISCO N3K series switches. In this guide, we will use the actual test on the N9K-C93180YC-EX switch as an example to demonstrate the configuration methods for breakout and aggregate of QSFP interfaces on the CISCO NEXUS 93180YC-EX switch:

1. In the default state of the device interfaces, the QSFP interface is in aggregated mode. When checking the interface, only one independent interface is visible, with a default speed of auto, which can be configured to 40G/100G.

2. In global configuration mode, execute the command interface "breakout module 1 port port_number map breakout_mode", this command breakout the merged QSFP interface. The tested model supports breakouting into 4 × 10G, 4 × 25G, or 2 × 50G logical interfaces, and the command takes effect immediately after execution.

3. After configuring the interface as a breakout interface, checking the interface will show that the originally independent single interface has been breakout into 4 × 10G interfaces.

4. In global configuration mode, execute the command "no interface breakout module 1 port port_number map breakout_mode" to cancel the interface breakout. At this point, the interface aggregates back to the device's default state.

ModuleTek Limited is at your service !

If you have any questions about the above content, please contact us via email: sales@moduletek.com

Back

PREVIOUS：How To Configure Interface Splitting And Aggregate On DELL S5224F Switches

NEXT：How To Configure Interface Breakout And Aggregate On The CISCO NCS 540 Switch

Hot Recommended

How To Configure Interface Breakout And Aggregate On The CISCO NEXUS 93180YC-EX Switch